HomeHome » Contact Us   » Inno IFS-10

Cable Installation Tools » Electrical Cable Pulling Tools

Proper Tools for Working with Electricity

Working with the power components of your house requires the right tools. This is not an area of home improvement or repair where you want to wing it.


Electrical contractors and electricians have their special tools of the trade. The tools needed for an electrical contractor fall into three major categories. They are basic wiring tools, system installation tools, and testing equipment. The basic tool kit of the electrician will contain many tools common to mechanical, plumbing, and household tool kits.


Screwdrivers and wrenches are needed, although the sizes tend to be smaller for an electricians tool kit than for the other trades. One special piece of equipment in the electrician’s tool box is the combination wire stripper/cutter. This special tool is used in the preparation for wiring. The typical stripper has grooves for most common wire sizes. The end of the wire is inserted in the groove and the stripper is closed. When the wire is pulled out of the groove, the insulation will be removed leaving the underlying wire exposed. The combination tool also is a wire cutter.


Installation tools are more expensive and not normally found in the average tool collection. These include special tools for bending and cutting conduit and tools designed for breaking through wall surfaces for the insertion of conduit. Another group of contractor tools enables the electrician to “pull” wire through enclosed areas. These are cable pulling or fish taping systems used in wiring.


Testing equipment is an important part of the contractor’s tool assortment. There is a wide variety of testing equipment. The most common is the Digital multimeter. There was a time when a multimeter was something you would only expect a trained electrician to understand, but the digital multimeter is now something that actually belongs in just about any home tool box. The most common function of the multimeter is to test circuit integrity. This is done by disconnecting power from an appliance and touching the negative and positive probes of the multimeter to each end of the circuit. If the resistance reading is zero, it indicates that the circuit is intact and will handle a current flow. The multimeter can test simple light bulbs in this manner. In the hands of an electrician, the multimeter can test much more than simple current.


A final group of equipment for an electrical contractor is safety related equipment. Electrical work has a high potential of danger. Safety equipment is the most important part of any electrician’s tool kit. Safety equipment includes eye protection, electrician’s gloves, and tagging equipment to insure that equipment is disconnected while work is being performed


Find an electrician at ElectricianCompanies.com.


Source: www.articletrader.com